North American manual · head variant matters

EGO ST1510T line size and head

The EGO ST1510T / ST1510T-FC operator manual specifies 0.095 in. (2.4 mm) nylon twist line. It describes the tool’s supplied bump head with POWERLOAD line-winding button.

Record: 0.095-inch (2.4 mm) nylon twist line. The listing is tied to the specific ST1510T family and manual, not every EGO tool.

What the manual identifies

Models covered: ST1510T and ST1510T-FC.
Line: 0.095 inch / 2.4 mm nylon twist.
Head: bump-feed head with a POWERLOAD button to wind line.
Recommended replacement line model numbers in the manual include AL2415S, AL2450S, AL2420P, and AL2420PD.

Before reloading

Check that the fitted head is the original POWERLOAD assembly. A physically similar replacement head may use a separate line specification. Use the manual’s full threading and winding procedure; do not run the tool without its guard firmly attached.

Manual edition and source

The source used here is EGO’s North American ST1510T/ST1510T-FC operator manual. It was checked on October 19, 2026. The source copy’s internal version/date was not independently established by this prototype. If the PDF provided for your serial range differs, defer to the tool-specific copy.

Open EGO ST1510T / ST1510T-FC operator manual ↗

Source: official EGO North American manual, checked 2026-10-19. Always verify the fitted head and latest applicable manual.